[pits200]

I'm not sure what might be around the corner with Vishnu but now with the fueling flash and some room to push the e85 content, I was hoping to revisit some of the Procede User settings.

Being FBO with 40/60 meth content, flashed DME and assume high level of ethanol content. What are the high level settings most people would use assuming avg outdoor temp, good running car, etc..

Are start boost, boost control gain and boost the only 3 parameters that can be changed? If so, what would your settings be.

Thanks

[Fully_Bolted]

I thought the sensor adjusted everything for you?

[JamesM3M5]

They haven't shipped any FF sensor kits, yet.

As for your question, pits, I dunno. Might want to email / call Vishnu since the E85 stuff is still beta and not supported via Internet forums.

[pits200]

Originally Posted by JamesM3M5

They haven't shipped any FF sensor kits, yet.

As for your question, pits, I dunno. Might want to email / call Vishnu since the E85 stuff is still beta and not supported via Internet forums.

Thanks, and no, I'm not going with the FF sensor just yet.

I just assumed since numerous logs and dynos showing E85 potential were popping up from Vishnu and co. that it was a little beyond beta discussion.