02-19-2016, 11:58 PM | #1 |
Registered
0
Rep 4
Posts |
Tire & Alloys Recommendations for the Experts
I have read so many treads about tires and alloys and I really don't know what the best setup is so am open to positive feedback. I wish to put the following on my 2013 320D Sport and I am looking for the following: Noise level (Low) Performance Value for money Looks good Will not rub on the wheel arch The alloys I plan to purchase are the following but I will also wish to keep the RFT functionality so tries are important Alloy sizes: Front - 19 x 8.5 ET38 Rear - 19 x 9.5 ET40 Can this set up be done without any complications, I turn to the experts on the forum? If anyone can make a recondition it will be very much appreciated because I am at a loss and I just want to find a solution before I splash out, Thx to all who provide feed back |
02-23-2016, 09:43 PM | #2 |
BimmerPost Supporting Vendor
2045
Rep 25,989
Posts |
Those specs will be fine on your car. Go for it!
__________________
VMR|Wheels | 714.442.7916 |
sales@velocitymotoring.com | www.velocitymotoring.com | facebook | flickr | Instagram |
Appreciate
0
|
03-06-2016, 11:08 AM | #4 |
Registered
0
Rep 1
Posts |
Where did you get your alloys from? I also have a F30 320d Sport, and looking to change as the official ones are damaged. Looking for value for money and good looks along with no technical difficulty. Thanks
|
Appreciate
0
|
03-07-2016, 10:18 PM | #5 |
Registered
0
Rep 4
Posts |
Alloy Link
Hi shajul,
The supplier that I was going to purchase my alloys from has gone but I found the same ones on eBay in England, thought you might want the link: http://www.ebay.co.uk/itm/19-NEW-BMW...YAAOSwMmBVzKeD Regards Mal |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|