09-14-2020, 01:45 PM | #1 |
Colonel
4163
Rep 2,319
Posts |
ACM | White on Bronze
|
09-14-2020, 11:12 PM | #2 |
Brigadier General
1690
Rep 3,200
Posts |
Looking sharp!
|
Appreciate
1
jeff@autocouture965.50 |
09-17-2020, 07:17 PM | #3 |
New Member
3
Rep 8
Posts |
Thank you for the post! I am the owner. The car currently has project gamma primary/secondary Downpipes, MSR intakes, DME tune, along with the mods listed above. All of which were professionally installed by Autocoture. Should have some more carbon goodies along with a cat-back exhaust to finish things off .
|
Appreciate
2
jeff@autocouture965.50 Matt@AUTOcouture4162.50 |
09-17-2020, 09:42 PM | #4 | |
First Lieutenant
248
Rep 322
Posts |
Quote:
|
|
Appreciate
3
|
09-17-2020, 11:05 PM | #5 |
Lieutenant
366
Rep 435
Posts |
ACM is hands down the best. Matt is so easy to deal with and very honest. I've emailed back and fourth with him for months about mods and always gives me his honest opinion.
|
Appreciate
2
F90nyc0.00 Matt@AUTOcouture4162.50 |
09-18-2020, 09:41 AM | #6 | ||
Colonel
4163
Rep 2,319
Posts |
Quote:
Quote:
|
||
Appreciate
1
GranitM5366.00 |
09-18-2020, 11:00 AM | #7 |
Captain
700
Rep 777
Posts |
A little bit too low for my taste, but damn that car looks good! Love the wheels!
|
Appreciate
1
Matt@AUTOcouture4162.50 |
09-19-2020, 06:27 AM | #8 | ||
New Member
9
Rep 19
Posts |
Front tire size? Any spacers?
Quote:
Quote:
Other than the custom bronze finish, these are standard Titan wheels? From the photos, i see you are running Michelin's in 305/35-20 in the rear. Are the fronts 285/35-20 or 295/35-20? Do you experience any rubbing in front or back before or after lowering? I am looking to go with Titan wheels and want to run 295s in front and 305s in rear at stock ride height but want to make sure there is no rubbing that occurs. Thanks!! |
||
Appreciate
0
|
Post Reply |
Bookmarks |
|
|