[mkereti4]

Hallo.
I have installed the LCI tail lights on my BMW F90 (G30) , repining, do the coding and everything works, but when i unlock the car and WELCOME LIGHTS turn on, the rear tail lights outter ones does not. Is that a problem with SOFT ON mode ? Can i code it to turn HARD ON on the rear ?

[bmw1928]

UP

[GTATX]

Copied from another post:

i can share more info on retrofit work，2 big rearlight are plug and play，light on the trunklid is more complicated -its socket has 6 pin and you can not do a direct retrofit，1-6 was turn signal，empty，ground，daylight，foglight，rear light，and there are redefined in lci as fog，rear，daylight，turn ，brakelight（new）and ground，you need to rewire brakelight and turn signal from trunklid to front right seat area where BDC module located

left side
Turn Signal Pin Movement: A258*5B 41-> A258*3B 50
New brake pin added: A258*5B 41
right
Turn signal pin movement: A258*5B 33 -> A258*3B 38
New brake pin added: A258*5B 33

look into manual book to locate these socket in bdc

finally use ista or esys to code - basically it is coding your prefacelift bdc module with a f90 lci version of file

the last but not least -share everyone some photos on my progress of building the car