Quote:
Originally Posted by ///WeissBlitz76
OK, so wound up just going with a dealer install, as they did it while I was out of town, and I just wanted to pick it up ready to go. At first, it looked ok, but tonight after I got in from a (very fun) little drive, I was playing around with it, found it to be a little bit loose, and then saw one side of it looking like this:
Attachment 2447972
If I press down on it, it will go down, but will obviously come right back up. If I could leave something attached to it, maybe it would hold it down? Otherwise, any ideas as to how to remedy this? The dealership is about 2.5 (inconvenient) hrs away, so taking it back, for this, is sort of not in play. Open to suggestions? |
Looks like they use double sided tape, not Betalink like their official install guide says.
If it is betalink, then whoever did the install, didn't do a proper prep job.
Either way, take it back. It is not supposed to happen.
Mines on with Betalink, and it is ROCK solid. I can't even imagine how I'm going to remove it in the future, that's how solid it is