Quote:
Originally Posted by bradleyjs
Thanks GT, I’ll give that a try!
|
Once we were able to get the larger cover off, we used the needle-nose pliers to push in each MirrorTap hot and ground wires into place and they very snug. One thing to look out for, which was a gotcha for me, the ground pin location was different in the schematic than it was actually located on the pin harness/connector. Well, it threw a check condition error with the ambient light sensor and the auto-wipe systems. I powered the car off then back on and it cleared the check condition message. Whew...!
After locating the “Brown” ground wire and of course the red/black 12V hot wire, it worked like a champ! The hardest part of the install was putting the cover back on. Took us (my oldest son and I) no more than 15 mins to perform the entire install.
Question:
Does leaving the Radenso Pro-M in the “Powered On” mode drain the battery in any way? It NEVER seemed to power off and some lights on the dash stayed on too - even after a 15+ mins wait away from car.