Quote:
Originally Posted by BMWDriverX
Quote:
Originally Posted by GTATX
ER secondaries won't clamp to primary. Tried hours still no use. Requested the company to do refund and return. Will figure some new route tomorrow.
|
Gintani had a similar issue installing my ER secondary's, they had to loosen up the primaries and then they managed to get them to fit after 8 hours. Then there was an issue with the ER pipes mating to the exhaust pipes they were a little too long and went past the flange on the stock pipes causing a small leak. I had to go to a different muffler shop to push the exhaust out towards the back of the car an 1/8" or so and clamp the secondaries down and finally they fit without leaking. ER is a crap company as i brought all this up to them and they told me they would call me back with a solution but never did. I figured i was the only one that had an issue as others have installed without issues but now you're the second one. I personally will never buy anything from ER again but in the end these pipes will fit you just have to install from the top down removing the stock primaries first.
|
I might just do something to OEM secondaries. Nothing will fit better than that and will keep OEM look.