Quote:
Originally Posted by adolzero
i can share more info on retrofit work，2 big rearlight are plug and play，light on the trunklid is more complicated -its socket has 6 pin and you can not do a direct retrofit，1-6 was turn signal，empty，ground，daylight，foglight，rear light，and there are redefined in lci as fog，rear，daylight，turn ，brakelight（new）and ground，you need to rewire brakelight and turn signal from trunklid to front right seat area where BDC module located
left side
Turn Signal Pin Movement: A258*5B 41-> A258*3B 50
New brake pin added: A258*5B 41
right
Turn signal pin movement: A258*5B 33 -> A258*3B 38
New brake pin added: A258*5B 33
look into manual book to locate these socket in bdc
finally use ista or esys to code - basically it is coding your prefacelift bdc module with a f90 lci version of file
the last but not least -share everyone some photos on my progress of building the car
|
Just to correct you, it is not coding the BDC with the lci file as the LCI G30 has BDC3 and pre lci has BDC2.