Hi guys,
I did search and couldn't find any how to on the install of the carbon fibre gear shifter so thought id take some pics along the way and give a brief explanation to make it easier for anyone trying this in the future.
Tools Needed:
Plastic Trim Tools
T7 Torx
First take a thin trim tool and pry out the Gear Intensity switch from the top of the lever.
Then remove the large plastic cover from the top of the lever, I found this was best done starting at the top. working the way down the edge and then pull upwards.
Remove the 4 torx t7 screws.
Starting at the top pry each silver side piece off working downwards, at the bottom you need to pull out and up.
Remove the lower plastic trim with the plastic lighting prisms. Start near the leather and pry towards the rear of the car.
Swap the switch rubbers & gasket from the old piece to the new piece, here you can see 1 switch rubber removed and one still in place at the top of the piece.
Follow the previous steps in reverse for installation. Please make sure you have transferred the switch rubbers and gasket prior to installation as once you've clicked the top cover on and rocker switch its too late to fix as you'll more than likely damage some clips removing the items again.
Hope this helps someone and makes the job a little easier.
Finished Article:
Thanks
Steven.