|
The ones from BMS as picture, have a smaller section, and you screw some grub screw to lock it from falling off. The pipe that is the actual exit in the exhaust for the car widens at the end, so the sleeve slips over, and the screws prevent it from sliding over the thicker part.
No mods required, but I purchased some shorter grub screw as as the ones that came with it poke out a little too much (they are about 14mm long) but only a depth of 6mm is required, then the screw is flush when tightened, effectively using them. Then I added a little thread lock to prevent any rattling loose.
Any more questions just ask. More than happy to post a little video of the fitting if it helps??
|